SoC White Box IPs

Visit us at Electronica

Nov 13-16 Munich

802.11 AC RF IP

개요특징Datasheet 요청하기


This dual band RF transceiver IP is a complete radio front-end, optimized for IEEE 802.11a/b/g/n/ac SoC implementation, based on the industry’s proven direct conversion transceiver architecture. The RF transceiver IP has fully integrated power amplifiers along with the capability of various commercial external FEM support. RF IO ports are single-ended and a fractional-N synthesizer while the power amplifiers and LDOs are fully integrated for minimum BOM and PIN counts.

The IP supports various radio calibration functions such as PAPD, TRX IQ mismatch calibration, LO feedthrough calibration, DC offset cancellation, fast AGC, VCO calibration, VCO temperature variation compensation, bias calibration, LPF corner frequency compensation, battery monitoring, and temperature monitoring.

The internal, digitally controlled gain stages at the RF and BB levels provide both low noise figure and large dynamic range for the receiver. In addition, the transmitter has more than 30dB gain range, which provides a wide output power range. The cutoff frequency of the baseband filters are calibrated with an internal RC compensation scheme while the low pass filter supports modulation bandwidths up to 80MHz. A crystal oscillator, which is connected to a low cost external crystal, is also integrated. The SPI interface controls most of the transceiver functions.



  • Dual band transceiver for IEEE 802.11ac
  • Compliant with IEEE 802.11a/b/g/n
  • Supports up to 80MHz channel BW
  • Integrated power amplifiers
  • Integrated LDOs
  • TX LOFT/IQ mismatch calibration
  • RX IQ mismatch calibration
  • Fast AGC using built-in RSSI
  • PAPD calibration
  • LPF calibration
  • PLL calibration
  • Bias current calibration
  • Support of external FEM modules
  • Internal temperature sensing
  • Internal battery monitoring
  • Benefits

  • Available as SoC White Box IP
  • Deliverables

  • Datasheets
  • Hard macro containing dual band IEEE 802.11ac radios
  • Integration support with baseband
  • Process node: TSMC 40 LP
  • Tech Specs

  • Single-ended RF ports Two supplies: 1.4V, 2.7V to 4.8V
  • Supply current: – RX: 75mA @ 1.4V, 10mA @ 3.3V
  • – TX: 60mA @ 1.4V 80mA @ 3.3V(Pout = +3dBm) 180mA @ 3.3V(Pout = +18dBm)
  • Frequency band: – 2.4 to 2.5GHz, 4.9 to 5.8GHz
  • Modulation bandwidth: – 10M, 20M, 40M, 80M Linear TX output power: +18dBm TX gain range: 30dB RX noise figure: < 3.5dB RX gain range: 80dB RX IIP3: -13dBm RX IIP2: +20dBm
  • Phase error: < 0.4 deg. for IEEE 802.11ac
  • Fast TX/RX switching: < 5us EVM: < -35dB @ 256QAM
다음 양식을 작성하고받은 편지함에 제품 데이터 시트를 가져 오십시오

T2M의 높은 퀄리티의 사전실증된 아날로그/혼합 시그널, RF, Digital and SW 시스템 해결책은 통신, 소비자와 컴퓨터 제품(IoT, Wearables, 핸드폰, 타블랫, M2M, RCU, set-top boxes, TV, 디비디 플레이어, PC 칩셋등)에 중요한 빌딩 블록으로 사용됩니다. IP는 소비자의 구체적인 요구조건에 따라fab/node 이식이나 전매 특징들을 수정할수 있습니다.