SoC White Box IPs

MIPI CSI2 Tx Controller IP

OverviewFeaturesRequest Datasheet

The MIPI Camera Serial Interface 2 (CSI-2) is an interface between a Camera and a host processor baseband application engine. This interface is defined by MIPI Alliance, which defines a series of modules in a MIPI compliant product. The MIPI CSI-2 Transmitter is used in mobile and high– speed serial applications as a controller for transmitting camera video and receiving camera commands to/from MIPI CSI-2 Receiver over MIPI lines. The camera data is encoded and then transmitted. The MIPI CSI-2 Transmitter along with our MIPI CSI-2 Receiver and MIPI DPHY provides a complete solution for decoding MIPI CSI-2 data.

Features

      • Compliant with MIPI CSI-2 Spec v1.1 and MIPI D-PHY Spec v1.1
      • Max 1.5 Gbps data transfer rate per Data Lane of DPHY
      • Programmable 1, 2 or 4 Data Lane Configuration.
      • Operate in continuous and non-continuous clock modes.
      • Command and Video Mode are supported.
      • Burst and Non-Burst modes are supported.
      • Video Packet Formats:YUV-422 8-bit, RGB-888, RGB-565, RAW-8, RAW-10 and RAW-12
      • Camera Interface: 8, 16 and 24 bpp
      • Progressive Scanning

Benefits

        • Silicon Proven
        • Highly Modular and Scalable Design
        • Active Low Asynchronous Reset

Deliverables

        • RTL Code
        • Verification Environments
        • Test suites
        • Synthesis Environment and Scripts
        • Design Guide
        • Verification Guide
        • Synthesis Guide

Please fill in the form below

T2M's range of high quality pre-verified, analog/mixed-signal, RF, Digital and SW system solutions, are used as critical building blocks of communications, consumer and computer products including IoT, Wearables, cellular, tablet, M2M, RCU, set-top boxes, TVs, DVD players and PC chipsets. IPs can be modified to meet the customer's specific requirement be it fab/node porting or proprietary features.