Your Complex IP Core Partner

    USB 2.0 PHY IP

    OverviewFeaturesRequest Datasheet
    The USB2.0 PHY IP is a complete physical layer (PHY) IP solution designed for low power and peak performance. The USB2.0 IP implements a High-Speed USB 2.0 transceiver for use with either host and device function controllers. Compliant with the UTMI+ level 3 specification, the USB2.0 PHY IP integrates mixed-signal circuits to support High-Speed data rate at 480Mbps and is backward compatible to Full-Speed (12Mbps) and Low-Speed (1.5Mbps) data rates. Targeting mobile and consumer product applications, the USB2.0 PHY IP also supports the supplementary USB Battery Charging specification. The USB2.0 PHY IP transceiver is optimized for low power consumption and minimal die area (sub-0.18mm2), without sacrificing performance and high-data throughput. The USB2.0 PHY IP comprises a complete on-chip physical transceiver solution with Electrostatic Discharge (ESD) protection, clock generation block provided by an internal PLL, and a resistor termination calibration circuit to ensure full support for host and device functionality.
    Fully compliant with USB 2.0 specifications • Supports the UTMI+ level 3 specifications • Supports USB Battery Charging • Supports 480 Mbps High-Speed (HS), 12 Mbps Full-Speed (FS), and 1.5 Mbps Low-Speed (LS) data transmission rates • Can be configured as host controller or device peripheral • Utilizes 8-bit interface at 60MHz operation or 16-bit interface at 30MHz operation • Supports USB 2.0 Test Mode • Built-in self-test mode to validate high-speed, full-speed and low-speed functionality • Single parallel data clock output with on-chip PLL to generate higher speed serial data clocks • Selectable input reference clock frequency (12/24/25MHz) • Available in both 1-port and 2-port configuration

      Fill the form below, to receive the product datasheet in your inbox