10/100/1000M Ethernet Transceiver
This GPHY is a highly integrated single chip for Giga 10/100/1000 Ethernet application. It is IEEE 802.3u/ab compliant single-port Giga Ethernet physical layer transceiver with low power consumption. It supports 10BASE-Te, 100BASE-TX, 1000BASE-T operation. This GPHY connects the Media Access Control Layer (MAC) by GMII(Giga Media Independent Interface) or RGMII. It could support Un-shielded Twisted Pair Category 5 Cable(UTP5) for 100BASE-TX Fast Ethernet and 1000BASE-T Giga Ethernet, or UTP5/UTP3 cable for 10BASE-Te Ethernet. It contains the entire physical layer function of 100BASE-TX defined by IEEE802.3u and 1000BASE-T defined by IEEE 802.3ab, including the Physical Coding Sub-layer (PCS), Physical Medium Attachment Layer (PMA), Twisted Pair Physical medium Dependent Sub-layer (TP-PMD, 100BASE-TX only). This GPHY also provides a robust auto-negotiation function, automatic media speed/duplex and protocol selection. GPHY also supports Auto MDI/MDIX function to simplify the network installation.
- Fully compliant with the IEEE 802.3 / 802.3u /802.3ab10BASE-Te, 100BASE-TX ,1000BASE-T
- Interface available to Compliant with TP-PMD standard:ANSI X3.263-1995, Compliant with FDDI-PMDstandard: ISO/IEC 9314-3: 1990 and ANSIX3.166-1990
- Support GMII / RGMII interface to the MAC controller.
- Serial management interface compliant with IEEE802.3u (MDIO)
- Support Full-Duplex or Half-Duplex Operation ,1000BASE Full-Duplex only
- Support Auto-Negotiation Next Page /Parallel Detectionfunction compliant with IEEE 802.3u/ab, and Manualconfiguration is also supported.
- Automatic Polarity CorrectionSupport auto MDI/MDIX crossover function for10BASE-Te / 100BASE-TX
- Embedded baseline wander correction (BLW) Circuit
- High Performance Digital Clock recovery algorithm
- High performance Digital Equalizer for ISI mitigation
- High performance Echo / NEXT canceller
- Support Wake-On-Lan (WOL) with magic packet
- Support efficient energy Ethernet (EEE), Compliant with EEE802.3az-2010
- Support automatic polarity swap
- LED Driver for Link, Activity, Duplex, Collision, andSpeed Status
- Low Power design, with support 803.2az standard-2010(EEE)
- Cable diagnostic Test (open/short/cable length)
- Programmable LED status of link