The DisplayPort transmitter PHY version 1.4 supports data rates between 1.62Gbps (RBR) to 5.4Gbps (HBR2). built-in equalizer with programmable analogue features, 100-ohm termination resistors, and common-mode biassing the CDR bandwidth, the regulator voltage, the BGR voltage, and the terminator resistance Support 1.8V/0.9V power supplies for internal analogue signal monitoring and PLL testing.
eDP version 1.4a / DP version 1.4 compliant transmitter
Supports HDCP1.4 and HDCP2.2(Optional)
Supports Forward Error Correction (Optional)
Consists of configurable (4/2/1) link channels and one AUX channel
Supports 1.62/2.7/5.4/8.1Gbps (HBR3) bit rate and all recommended link rate (ie 2.16Gbps etc)
Supports main link operation with 1 or 2 or 4 lanes
Supports both Default and Enhanced Framing Mode
Supports SST mode
Supports video packet and audio packet (8ch max)
Supports both Normal and Alternate Scrambler Seed Reset
Supports E-EDID data reading via I2C-over-AUX transaction
Supports Video test pattern generator (compliant with DP link CTS v1.2)
Configuration registers programmable via AMBA interface
Silicon Proven in UMC 28nm HPC+
Deliverables
Verilog RTL or netlist source code of LINK controller.
Abstracted timing models for synthesis and STA
Timing constrains for synthesis and physical layout
Behavioural Verilog Model, simulation test bench, run control scripts, and test stimuli
Physical design database
Integration guidelines
Reference software sample code
