A wide variety of PCIe 2.0 Base applications are available with PCIe 2.0 transceiver IP. It adheres to the PIPE 3.0 standard. In order to enable PCIe 2.0 traffic at 5Gbps and be backward compatible with PCIe 1.0 data rate at 2.5Gbps, this IP includes highspeed mixed signal circuits. It is designed to consume less power and have a small die area. The PCIe 2.0 IP may satisfy the needs for various channel circumstances since it supports both TX and RX equalisation approaches.
Compatible with PCIe base Specification
Full compatible with PIPE3.0 interface specification
Independent channel power down control
Implemented Receiver equalization Adaptive-CTLE to compensate insertion loss
Support 16-bit/32bit parallel interface
Support for PCIe gen1(2.5Gbps) and PCIe gen2(5.0Gbps)
Support flexible reference clock frequency
Support 100MHz differential reference clock input or output (with SSC optionally) in PCIe Mode
Support Spread-Spectrum clock (SSC) generation and receiving from -5000ppm to 0ppm
Support programmable transmit amplitude and Deemphasis
Support TX detect RX function in PCIe Mode
Support Beacon signal generation and detection in
Production test support is optimized through high coverage at-speed BIST and loopback
Integrated on-die termination resistors and IO Pads/Bumps
Embedded Primary & Secondary ESD Protection
ESD: HBM/MM/CDM/Latch Up 2000V/200V/500V/100mA
Silicon Proven in TSMC 12nm FFC
Deliverables
GDSII & layer map
Place-Route views (.LEF)
Liberty library (.lib)
Verilog behaviour model
Netlist & SDF timing
Layout guidelines, application notes
LVS/DRC verification reports
